Bluesound Powernode Setup Guide download pdf (Page 14)

MUTE

. Press to temporarily mute audio output. Press again to restore audio from mute mode.

. When MUTE mode is selected the LED indicator will flash blue.

FACTORY RESET

The LED INDICATOR/MUTE button is also used for restoring the POWERNODE to its factory default settings.

1. Unplug the power cord from the wall outlet or unplug the other end of the power cord connected to POWERNODE’s

AC mains input.

2. Press and hold LED INDICATOR/MUTE button and then connect the power cord to the wall outlet or the other end of

the po wer cord to POWERNODE’s AC mains input.

3. Do not release hold on the LED INDICATOR/MUTE button; wait until it flashes red and then release. The

POWERNODE will reset and reboot itself to Factory Settings.

4. When the LED INDICATOR/MUTE button ends up at soli d green (Hotspot mode), the POWERNODE has been reset

and is ready to be configured again.

2) +, - (VOLUME)

Toggle either button to vary volume level. Volume level will not change if you press and

hold either button.

+ : Increase volume level.

- : D ecrease volume level .

3) AC MAINS INPUT

The POWERNODE comes supplied with two separate AC power cords. Select the AC power cord appropriate for your region.

. Before connecting the plug to the wall outlet, connect firmly first the other end of the AC power cord to POWERNODE’s AC

Mains input socket. . Never force the plug into a wall outlet. An adaptor may be necessary in certain regions.

. Always disconnect the pl ug from the wall outlet first, before disconnecting the cable from the POWERNODE’s AC Mains

input socket.

4) SPEAKERS

. Connect the right speaker to the terminals marked “R +” and “R - ” ensuring that “R+” is connected to the “+” terminal on

your loudspeaker and “R - ” is connected to the loudspeaker’s “ - ” terminal. . Connect the left speaker to the terminals marked

“L +” and “L - ” ensuring that “L+” is connected to the “+” terminal on your loudspeaker and “L - ” is connected to the

loudspeaker’s “ - ” terminal.

. Use extra care to ensure that no stray wires or strands cross between posts or terminals at either end.

5) SUBW (SUBWOOFER) OUT

A Subwoofer can also be connected directly to the POWERNODE . Connect SUBW OUT to a powered (“active”) subwoofer.

6) USB (TYPE A)

Connect a USB mass storage device to the USB input. Typical USB mass storage devices compatible with POWERNODE

include portable flash memory devices and external hard drives (FAT32 formatted).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 57 58

No comments

Bluesound Powernode Setup Guide Page 14